High Frequency Battery Charger:
LADE-LIGHT
POWER-SWITCH
Low Frequency Battery Charger:
EFFICIENT DATA MEMORY
MGX MEMORY CHARGER
High Frequency
Battery Charger
POWER-SWITCH represents the whole range of high-frequency battery chargers (single-phase, single-phase with PFC, three-phase, three-phase with pump), completely developed by our technical office. They are suitable to charge both wet and sealed GEL or AGM lead-acid batteries, with capacity from 30Ah to 2800Ah. The recharge time varies from 6.5 hours to 13 hours. The recharge cycle occurs correctly even in presence of wide fluctuations of the mains voltage.
All devices can be also installed on-board, they are fully programmable and endowed of data memory systems to keep under control the energy package conditions of use (battery and battery charger).
POWER-SWITCH is the right choice:
- When a high energetic efficiency is needed to limit recharge costs.
- When electric power costs employed in recharge rooms have to be reduced.
- When it is important to limit stocks in stores and to satisfy all market needs through the use of few models.
- When high-frequency technology is required, but there is a tight budget.
- When shipping costs have to be reduced.
- When an air freight is needed.
- When there are wide fluctuations of the mains voltage.
- When the battery charger has to be installed on-board.
- When the working environment is safe and decently clean.
Tips for a correct use:
- To hang the device on the wall, together with its own ABS roof (where it is included).
- Not to leave them in the water, in such cases LADE-LIGHT series should be preferred.
- Not to use them in very dirty environments, in such cases EFFICIENT DATA MEMORY or LADE-LIGHT series should be preferred.
PSW POWER SWITCH single-phase models
High Frequency Battery Charger
- Efficiency: >85%
- Work environment temperatures: -10°C / +50°C.
- IP20 protection degree.
- Minimum battery voltage to allow the charging cycle to start: 1.00 Volt/cel.
- Maximum charging times considering the battery discharged no more than 80%.
- Mains cable: 2mt.
- Output cable, coupled: 2.5mt.
- Pallet size: 800 x 1200mm.
TECHNICAL SPECIFICATIONS
